ÌÇÐÄVlog

Please consent to cookies to view content.

' ); iframeDoc.close(); } } } } } const observer = new MutationObserver(switchSrc); observer.observe(document.documentElement, { childList: true, subtree: true, }); })();

ÌÇÐÄVlog

Last updated

18 November 2026

pdf, 1.08 MB
pdf, 1.08 MB

Four sheets on sectional views to AS 1100:

05 Full section, with counterbores and an oil hole
06 Half section with webs and an external thread
07 Offset section, with a tapped hole
09 Full section with a rib, which is not hatched when cut lengthwise
Every pack includes: a front page with contents, marks and timing • each sheet with a 5 mm grid and plain like the exam • large full-size drawing areas with starting points marked • a full answer key with a mark-by-mark guide • AS 1100 conventions, third-angle projection, A4.

All parts are original and modelled in 3D, so every answer is exact. HSC-style practice written to match the drawing skills tested in recent HSC Engineering Studies exams. Not past-paper questions. Sheet numbers match the Drawing Revision Kit.

Written for the NSW Stage 6 Engineering Studies syllabus (Year 11–12 HSC): engineering drawing and AS 1100 drawing standards.

Reviews

Something went wrong, please try again later.

This resource hasn't been reviewed yet

To ensure quality for our reviews, only customers who have purchased this resource can review it

to let us know if it violates our terms and conditions.
Our customer service team will review your report and will be in touch.